Aye…there’s not a lot of sense in this, unless you’ve lived it.
Imagine you have a few sinks in the house that enjoy clogging up, due to grubby kids, or soap build up, or whatever. And the only solution is to disassemble the drain valve, which is gross mess every time.
So design yourself a SINK SIZED PLUNGER!!!!! Because toilet plungers won’t fit. I also needed a reason to experiment w/ Prusa + flexible filament.
Prusa w/ flex filament, apparently like ALL flex filaments, especially of low durometer, is tricky. No exceptions here.
Yes, it works.
Yes, I’ve used it several times.
Yes it sticks really well to a kid’s belly. And dad’s belly. Windows. Foreheads. Sides of the tub.
YES, it makes a satisfying MMPOP! when you pull it free.
Yes, if you stick it really well to your shoulder it is actually difficult to remove, and pulls enough suction to actually hurt, it’s surprising.
The wall thk for cup is ~0.06in, printed in Filaflex 40. Handle is PLA.
